Nevion VikinX Sublime series Rev.G Instrukcja Użytkownika Pobierz pdf (Strona 29)

VikinX Sublime Optical Routers Rev. G

nevion.com | 29

7 Control Panel operation

This chapter is only applicable for routers with the optional local control panel.

All local control panels are completely configurable with the Nevion Configurator, which is

downloadable from the Support pages at http://www.nevion.com/

All local control panels are given a default configuration, which includes the buttons “A/V

Toggle”, “Panel Enable”, “Take on/off” and “Take”. In addition input and output buttons are

preconfigured.

7.1 Button description

7.1.1 A/V Toggle

The A/V Toggle button enables/disables audio and video on a specified address. The

address can either be read from the dip switches, or be fixed. The button toggles between

three states.

If the button is pressed for more than 1 second, it will go into a fourth state

where both audio and video are disabled.

In this state the button will be dimmed. If the button is pressed for more than 1 second

again, it will enable both audio and video if present.

Button Color

Video Enabled

Audio Enabled

Yellow

Yes

Green

Yes

Red

Yes

Dimmed

If neither audio nor video is present, it will be marked as disabled and the toggle state will

not be used.

Toggle status changes will be stored in flash and used when the panel is powered up later.

7.1.2 Panel Enable

The panel always starts in disabled mode. In this state the button will be red and all the

other buttons will be disabled. When pressing the button the panel will be enabled and the

color will change to green. A status request will also be sent to get information on active

levels.

7.1.3 Take on/off

The Take on/off button enables or disables the Take button. If no take button is defined,

Take on/off is always off. On first start-up the take button is enabled. Later it will read the

last status from the flash memory.

7.1.4 Take

The Take buttons LED is normally off. If the Take on/off button is set to “on”, no commands

will be sent from the panel until the Take button is pressed. The last selected buttons and

the take button will blink, until the Take button is pressed and the command is sent from the

panel.

7.1.5 Output

An Output button is used for selecting an output. Selecting an output activates it, so that it is

switched to the next input that is selected.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Komentarze do niniejszej Instrukcji

Brak uwag

Nevion VikinX Sublime series Rev.G Instrukcja Użytkownika Strona 29

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Routery Nevion VikinX Sublime series Rev.G